Validate Spot Heights (Defense Mapping)
サマリ
Validates spot heights against contour tops in Esri Defense Mapping data models. This tool validates two conditions: a spot height is higher than or equal to the contour top that contains it and the contour top is not missing a contour line (based on contour interval) between it and the spot height. The tool creates a selection set of spot heights that fail this validation.
使用法
-
The tool selects features in the Spot Features feature layer that do not pass validation. Review values in the Point Height Field of the selected features.
Contour tops refer to an elevation completely surrounded by lower elevation contour lines. Contour tops must be polylines that start and end at the same vertex.
This tool selects no features if no Spot Features lie within contour tops.
Contour Interval is used to determine if there is a missing contour line between the contour top and spot height. For example, if Contour Interval is set to 20 and the elevation difference between the spot height and contour top is 40, the spot height would fail validation and be selected.
構文
| パラメータ | 説明 | データ タイプ |
in_contour_features |
The input contour features against which spot heights will be validated. | Feature Layer |
contour_height_field |
Field in input contours that contains elevation values. Field type must be numeric. | Field |
contour_interval |
The interval, or distance, between contour lines. This can be any positive number. | Long |
in_spot_features |
An existing Defense Mapping point feature layer that contains spot heights to validate. | Layer |
point_height_field |
Field that contains spot height elevation values. | Field |
コードのサンプル
The following example demonstrates how to use the ValidateSpotHeights tool.
# set GP environment
arcpy.env.workspace="c:/data"
arcpy.env.addOutputsToMap=True
# script variables
contourFeatures="Contour.gdb/MGCP/ContourL50K"
contourLayer="contours"
contourHeightField="ZVH"
contourInterval=20
spotFeatures="CARTO.gdb/CARTO/EGB_SPOTS_P"
spotLayer="spotHeights"
spotHeightField="ZVH"
# make two feature layers
arcpy.MakeFeatureLayer_management(spotFeatures,spotLayer)
arcpy.MakeFeatureLayer_management(contourFeatures,contourLayer)
# execute ValidateSpotHeights
arcpy.ValidateSpotHeights_defense(contourLayer,contourHeightField,contourInterval,spotLayer,spotHeightField)
# check for a selected set of features
desc=arcpy.Describe(spotLayer)
selectedFeatures=desc.FIDSet.split(";")
if len(selectedFeatures) > 0:
print "Found %s features that failed validation." % str(len(selectedFeatures))
else:
print "All features passed validation"